cad for planting

[SOLID]

Hello everyone,
I am not an expert in this field, but I need your opinions about the most widely used software in building design for thermal and electrical systems (both for design and sizing or verification).
Thank you!

 

[gfrank]

Thermotechnical : for the design, verifications ex l. 10 and compilation of ace/aqe by now the sh have been "obligated" to the certification of its software.
see on the website of the cti certified software/ pending certification produced by the various sh.http://www.cti2000.it/index.php?controller=sezioni&action=show&subid=34which normally (I don't know all) have a data impt type "graphic", some are also equipped with graphics (+o- advanced in 3d)

the same sh have additional products specific to the thermal and similar plants (type : fire prevention, gas sizing, air, etc.)

 

[SOLID]

and at the level of ease of use, completeness of tools, quality price ratio what would you recommend?

 

[gfrank]

depends a lot on the modules added to the base sw, however in the sh sites you find the prices, which then normally are subject to discounts ....
the most used are eilclima, acca, mc4, but I do not want to wrong someone ... everyone has their own qualities and defects ... like all the software