doriano
Guest
Good morning to all
This question is for everyone but especially for those who know the "shett metal" form I have to design a thick carter. 3 mm with bending and welding, plus I have to weld some sheets of various thicknesses.
All this I have to draw to send to build.
I did so: (but I don't know if it's the right solution) with sheet metal I ran a part of carter after I added some body and I inserted some sheets, etc. etc. and here comes the problem, wanting to make the separate design of the single sheets (to be sent in dxf) does not make me open the single pieces. Where am I wrong?
This question is for everyone but especially for those who know the "shett metal" form I have to design a thick carter. 3 mm with bending and welding, plus I have to weld some sheets of various thicknesses.
All this I have to draw to send to build.
I did so: (but I don't know if it's the right solution) with sheet metal I ran a part of carter after I added some body and I inserted some sheets, etc. etc. and here comes the problem, wanting to make the separate design of the single sheets (to be sent in dxf) does not make me open the single pieces. Where am I wrong?