cartridge: rounded parts with invisible lines.

[mdbosca]

Bye to all,
I've been looking all over the forum and don't talk about it. . .
in the cartilage when I put a part with pickled edges, the end lines rounding are lacking. Do you understand?
I lose a lot of time drawing manually with the sketch..
the attached design speaks for itself.
thanks for the attention!

 

[Peppe]

Did you activate the tangent edges?
if the single part is untouched they are usually activated by default, if you untouch a set you have to activate them at the time of the view positioning.

 

[mdbosca]

Did you activate the tangent edges?
if the single part is untouched they are usually activated by default, if you untouch a set you have to activate them at the time of the view positioning.

Thank you, that was it!! But even if I insert one part I have to scourge each time. is it not possible to leave flagged by default?

 

[Tarkus]

Thank you, that was it!! But even if I insert one part I have to scourge each time. is it not possible to leave flagged by default?

It would be right for me to be default.
I have been trying for several years, even trying to set this option on the template. Nothing to do.
If anyone knows how to make a beer...

 

[MauroM]

But in all these years, is this the first time you have this need?

 

[Filo]

...
If anyone knows how to make a beer...

beer offered by me too!

Hi.