catch v5

[mekeuro]

Hello, guys, I'm attending a catía course v5 r15
at home I would like to practice, I have a brand new notebook hp pavilion dv6; intel processor i5 with 2.27ghz; ram memory 6gb; 64bit operating system
because every time I open or close a card for example a part design, assembly design, various bookcases, fem analysis, in short all that is in the first left bar (start), the computer goes to stall and takes from 3 to 4 minutes to complete the operation.
However, once the card is loaded (part design, fem analysis, library, or other ) it evolves quickly!
Is it possible that this is a PC problem? : eek: eek:
I look at the tutors on youtube and see how to open and close these cards quickly.
Help me, thank you

 

[ferrezio]

on 64-bit and win7 machines it is preferable to install more current and above all 64-bit realizations.

Hi.

 

[stef_design]

install the r20 and you will see that you solve your problems:finger:

 

[The_Matrix]

install the r20 and you will see that you solve your problems:finger:

... and above all talk about v5r15 in the v6 forum is very appropriate. . :tongue:

 

[ing.sentenza]

Hi, I just made a film.
I wanted to know if there is a manual or an anlysis and simulation tutorial the environment of the structural calculation of catia v5
hello to all thanks

 

[luca.S]

hi to everyone, I just recorded myself and I was looking for answers to the installation of catia 5 on windows7, but I did not understand where I have to leave the message, because here where I write is the most recent mess I can find in the blog that concerns catia.

hello to all and thanks

 

[The_Matrix]

hi to everyone, I just recorded myself and I was looking for answers to the installation of catia 5 on windows7, but I did not understand where I have to leave the message, because here where I write is the most recent mess I can find in the blog that concerns catia.

hello to all and thanks

go under the forum catia v5...