center contenuti

[simpson]

hello to all
in inventor suite 2010, is there a possibility to keep the center open during assembly?
I ask you this because every time I go on : assembly board component group position from center content. ,...... before you start the c.c. it takes a few seconds
someone knows why

 

[PabloPicasso]

I don't think you can. but on 2011 you have the function "change measurement" on the right mouse button

 

[simpson]

I don't think you can. but on 2011 you have the function "change measurement" on the right mouse button

excuse but with "change measure" what can be done

 

[PabloPicasso]

if you have taken for example a bollon of a family, you can change its attributes (length and diameter) without having to open the contained center again and take a new object