cgr display in drawing

[Gianni1986]

Hello.

today afternoon working with catia v5, I found a new type of problem to which I have not yet managed to cope,

practically after modeling a solid in 3d I went to the table (drawing ), but I noticed that some details correctly represented in 3d were not reported in the 2d, but going into property and setting the cgr display and therefore not the exact one, all changes are reported however in this display I can not enter the quotas. I'd like to know if any of you could give me advice on this, thank you.

 

[falonef]

That's how it is.
if you make a view with the cgr format you cannot enter quotas, at least until the r20.

 

[falonef]

quotas of drawings with cgr "should be"to be possible from the r24...