change to frame copy

[deep70]

Hello everyone, I'm not a great expert inventor, I'm with the following problem:
I have built a frame with the appropriate generator, which being almost identical to another frame, I have proceeded to make a copy with its different code of course, now in the first frame I have run holes on tubulars, but I realized that the holes appeared also in the second frame (the copy) this is due (by my error or for what reason I do not know) for the fact that the frame is not copied but remains the same for both frame or suppress the holes in the second frame somehow? (I tried to suppress them precisely but this happens for both).
Thank you very much in advance for any given answers and good evening to all.

 

[DrBarde]

if the frame is the same unfortunately must remake the copy procedure.
I would recommend using design assistant to avoid copy problems, since the frames are quite delicate.

 

[deep70]

if the frame is the same unfortunately must remake the copy procedure.
I would recommend using design assistant to avoid copy problems, since the frames are quite delicate.

and if I change mome to frame 2?

 

[DrBarde]

should check that you also change all components under the frame, do not lose jobs and/or have no strange connections. change the folder where it is saved.
can try, but I'm not sure of the result.

 

[Peppe]

Save. here.

 

[deep70]

thank you very much and all for the answers given very useful and decisive. thank you so much again and good day to you very kind.