EukUn
Guest
hello to everyone, I'm busy with a nice air compressor!
until we are in assembly no problem but in kinematics begin the pains, and, as I want to understand what I am wrong I have left, as they say from my side, dapprincipio.
in yellow you see the tree, that green thing is the lid, and then, subjected to treatment of flexible/rigid secondary assembly, we see the bearing in the three parts. Now, the bearing alone moves quietly as it should, but if I go to mount the whole complex I have two contrasting results.
in assembly I have a degree of freedom (rotation) for all objects connected to the tree (then tree, inner ring and roller crown), but when I move into kinematics all the constraints go to ramengo and or rotate all the bearing or do not rotate at all.
ideas? :frown:
until we are in assembly no problem but in kinematics begin the pains, and, as I want to understand what I am wrong I have left, as they say from my side, dapprincipio.
in assembly I have a degree of freedom (rotation) for all objects connected to the tree (then tree, inner ring and roller crown), but when I move into kinematics all the constraints go to ramengo and or rotate all the bearing or do not rotate at all.
ideas? :frown: