clarification on positioning holes

[cacciatorino]

Then I just can't figure out what it is to draw the lines of the quadrants. . .

to respect certain symmetry rules.

For example, if the holes are referred to a dial, the holes positions will follow the geometry constraints on which they are supported. If you use the "free" points you have to quote one by one and the changes become more complicated.

 

[Parametric_Ozzy]

to respect certain symmetry rules.

For example, if the holes are referred to a dial, the holes positions will follow the geometry constraints on which they are supported. If you use the "free" points you have to quote one by one and the changes become more complicated.

no ok this is clear to me and I fully agree on the system , I often do so too in pro/e, but once designed the dial instead of leaning at the top of the segments there is no possibility to use an intersection point and then reuse it in the hole tool?
correct me if you're wrong, but I think I understand that since you already recognize the point, you must then convince him to the intersection of the tops of the dial.

 

[Mike1967]

I'm making a plate with laminated holes to mount ball recirculation skates.

once the hole command is activated and the type of hole encounters three problems:

1) the size of the lamato hole proposed by swx is at least imaginative, where do I correct them?

2) when I go to design geometry to place my holes, for example 4 rectangles as in the attached case, then swx does not let me use the tops of the geometries to put directly the hole for the fact that there is already a point in that place. for now I have not found better than putting the hole near, and then touch the summit of the rectangle and the center of the hole and give it the bond of coincidence. with 16 holes this takes away time.

3) If I want to quote the position of the rectangles (the quota 150 in the attached example) I find no other way than to put a construction point in the middle of one of the sides, but thus swx thinks that I want to put a hole, which I do not want. Do I have to resort to additional auxiliary geometries to put this quota "150"?

3) no, tap the line with the quota stumento and right click on "select middle point".
edit:
ops, sorry old, I missed your msg...