clay pneumatic carving

[cougarz]

Does anyone know how to make pneumatic sculptural with creo? possibly by excavating (material removal) rather than a relief (material addition)
profile design is a trivial "zigzag" I designed in 2d but I couldn't apply it to the surface with double curvature of the tire

 

[MassiVonWeizen]

scavo scolpitura battistrada pneumatici

Ciao a tutti sto disegnando uno pneumatico riproduzione di moto d'epoca, qualcuno sa indicarmi se è possibile scavare qualcosa del genere? attacco foto

www.cad3d.it

 

[AlbeLav]

Hi.
I have done so many, the road depends on what level of accuracy you want to get.

you can start using the "toroidal filling" function.

What is your end?

 

[meccanicamg]

However the right section was that of creo and not this of mechanical design.

 

[mamobono]

However the right section was that of creo and not this of mechanical design.

right

while someone moves it, I give him a solution of the problem made with wf 4, attached.
If you do the series then you get the whole wheel.
if cougarz you are an aficionado of vintage motion maybe made to feel for your opinion on my motion zundapp mc 125 of 1974.

Hi.

 

[AlbeLav]

Here's an example of how I modeled time ago the tyre treads.
It is a complex process, but so you get a geometrically rather precise result.