GiovaP
Guest
Hello everyone, I'm not a great ansys expert, but some things inside the apdl module are able to do it. .
I wanted to understand if it was somehow possible to move a model already completely defined, without having to cancel the mesh and start again.
Probably the thing is easier in workbench, so I would need some advice to do the thing.
all my problem arises from a transient analysis with the use of cmomega tied to table: ansys continues to say that there is a mistake in the definition of the rotating element that is not defined along the axis of rotation, which is not true because I have expressed it in cmomega the vector that contains the elements in rotation.
The problem may be hidden somewhere else, but at the moment I don't know what to say. .
always linked to the cmomega command I also have tables to update properties related to combi214 elements that must follow the internal variable(?) omegs, does anyone have suggestions and experiences?
thanks in advance:smile:.
I wanted to understand if it was somehow possible to move a model already completely defined, without having to cancel the mesh and start again.
Probably the thing is easier in workbench, so I would need some advice to do the thing.
all my problem arises from a transient analysis with the use of cmomega tied to table: ansys continues to say that there is a mistake in the definition of the rotating element that is not defined along the axis of rotation, which is not true because I have expressed it in cmomega the vector that contains the elements in rotation.
The problem may be hidden somewhere else, but at the moment I don't know what to say. .
always linked to the cmomega command I also have tables to update properties related to combi214 elements that must follow the internal variable(?) omegs, does anyone have suggestions and experiences?
thanks in advance:smile:.