collision control

[disney]

Bye to all,
I tried to search, but I didn't find anything to help me solve my problem.
I shaped a ski mask with relative chela x the fixing of the elastic.
with a summary control I checked that after a rotation of 20° the chela collides with the mask frame.
I remember that during a course, where ozzy was the instructor, you had seen the collision control of the assembly, but I do not remember how the particular was assembled to do this verification.
the chela in question has a pin where it is free to rotate and a joke that stops the transversal movement.
Can you help me figure out how this works?

Hello and thank you

milk

 

[maxopus]

more than a collision control you want a rotation cinematism with limits on rotation itself, right?
If so (even if an image on your part would help you understand better) you should use a pin bond.
in the same you can indicate the translation and rotation limits with minimum and maximum values

 

[disney]

That's right.
I'll put an image and the place down tomorrow.
but where do I express the limits of rotation? I tried today but I don't see where to put them in.

Hi.
milk

 

[maxopus]

That's right.
I'll put an image and the place down tomorrow.
but where do I express the limits of rotation? I tried today but I don't see where to put them in.

Hi.
milk

Here, see image attached.

 

[disney]

Hello, I don't get something back, but do I need a special license x collision control?
I can't bring the pin bond window into your situation.

Hi.
milk

 

[maxopus]

Hello, I don't get something back, but do I need a special license x collision control?
I can't bring the pin bond window into your situation.

Hi.
milk

you must first establish the translation bond, otherwise the rotation axis does not activate, look at the footage:
www.aureaprogetti.com/filmati/vincolo_pin/vincolo_pin.html