come creare mesh

[unical3d]

Hello everyone... I have a cloud of very thick points acquired with a leica scanner and some areas are beaten several times but I can't delete points because I would have after shadow zones. I have to get the 3d model with the demo of geomagic 12, I carry it in ptx from cyclone to keep the information rgb only that when I go to meshare the result is not good because it is as if it created multiple layers of mesh that intersect... you know how to tell me how can you solve by pointing out the various steps to do?? ? Thank you very much

 

[maxopus]

Perhaps it would have been better to post the discussion in the reverse area.
I will ask the moderator to move it and give it a more appropriate name.

in geomagic there is the global recording function for the reduction of small disconnections between the various shoots and the elimination of overlaps.
I do not know though if the individual past is kept in the passage from cyclone to geomagic.
In addition, if disconnections are macroscopic, the program algorithm may fail to correct them.

In cyclone, there is no correction function of this kind? I think it would be much better if you did it who scanned it.

who scans must give you a decent file, it's not that he can deliver it to you without even checking what he did...

However it is difficult to give a judgment without seeing the file.

n.b: I wait for the geomagic demo not to export (stl or neutral formats in general), save only in the proprietary format (.wrp).

 

[unical3d]

in practice I have to eliminate overlaps, the function that does it is the global registration? in geomagic there are single scans and the error between them is really very small. . .exist with manual registration a command that should delete points by chance deletes those that overlap and know how it works?

 

[maxopus]

in practice I have to eliminate overlaps, the function that does it is the global registration? in geomagic there are single scans and the error between them is really very small. . .exist with manual registration a command that should delete points by chance deletes those that overlap and know how it works?

manual recording is used to combine clouds of points that were taken from different positions.
the adjustment of small disconnections is done with global recording.

 

[unical3d]

but with global registration you can delete the points that overlap or keep them all?

 

[maxopus]

but with global registration you can delete the points that overlap or keep them all?

after making the registration you can recalculate the distribution of the points, according to a certain distance or a percentage.
You can do it even after converting everything to mesh.