command filettatura

[teseo]

Bye to all,

I have a doubt about the command "filettatura"
I must perform a female fillet in a plate; I should print it in 3d and then I wanted to use the thread command:

I have a doubt;
I ran a hole to males from m6, then I did the thread command by selecting cut; and therefore the tap metric profile, it would not be right to choose die metric .... .
If I choose die metric it cuts me in the void and so it doesn't make me do it
tap is the male while die is the nut or female hole?


I'm wrong

Thank you.

 

[MassiVonWeizen]

under the type find thread method with size or extruding
metric die is the supply chain while metric tap is the male https://en.wikipedia.org/wiki/tap_and_dietherefore in the function is specified not the hole but the tool that represents the processing