command "mesh"

[tetuti]

Hello everyone,it is the first time I write on this forum...I would have a problem in creating a hilltop.I used the mesh command and extruded but I created a series of solid "cake effect"! I would need to have a more likely effect. thank you all:wink:

 

[DarthVader]

Why did you use the extruded command?

 

[tetuti]

to create a three-dimensional element. .is there another way to do that?

 

[DarthVader]

to create a three-dimensional element. .is there another way to do that?

draw the mesh in the plant, draw the level curves and check at the points a quota. the emento is already three-dimensional. in archicad everything is already three-dimensional when drawing it

 

[tetuti]

I attach the image file of what I have created("the cake"):biggrin:..vorrei make less clearly the difference of altitude between the curves

 

[DarthVader]

Yes, but here you seem to have made 3 different mesh, or 3 different soles.
instead you have to draw only one mesh, draw in the polylines of the curves of the level and give the odds to these polylinese

 

[tetuti]

in this way do I still have the effect of three different levels or a more uniform design? ..thanks now cmq c I try:finger:

 

[tetuti]

ehmmm.. So I have to associate the spline with the mesh points so that even this is changed? How do I do that?

 

[DarthVader]

with the magic wand with the selected mesh tool. you get uniform and not like hell spins

 

[tetuti]

:biggrin:thank you...I put myself to work!!ehmm I know it is horrible hahah