command "undo" its solid edge

[Tequila]

I would like to know how many of you work the "undo" command said also cancels or simply ctrl+z.

it never worked out or hits only in environments where it wants.
I'm on a set, I select a particular and replace it with another,
I realize I have selected the wrong piece, I press cancel (ctrl+z) or
also the command at the top left on the st but does nothing, become gray.

even on dfts if I remove a view and I realize I've done stupidity, if I do ctrl+z it doesn't do anything to me.

but if you can't cancel or go back a few steps? ? ?
the problem I carry it back from v17 and on the st they had assured me that it had been settled.
I wanted to know if you have the same problem, or if I'm the loser.

 

[Leso]

I also noticed that for certain commands the grape does not work, it almost seems that you do not want to remember that operation. I don't know if it's because the management of complex operations would weigh too much... but it's weird.

 

[Tequila]

I also noticed that for certain commands the grape does not work, it almost seems that you do not want to remember that operation. I don't know if it's because the management of complex operations would weigh too much... but it's weird.

No, no heavy operation, it just doesn't work.

 

[Marco74]

No, no heavy operation, it just doesn't work.

"o pienamente. ...

ciao.

 

[Be_on_edge]

the commands for which it is not expected the grapes ask confirmation before being executed. I don't know how to answer that.

Hi.

 

[Tequila]

the commands for which it is not expected the grapes ask confirmation before being executed. I don't know how to answer that.

Hi.

Look lately I don't know how he thinks solid edge. I made some changes this morning to a set, I changed a seeger and a seal ring, putting them bigger.
I mistakenly replaced the seeger with the seal ring (I do not use the standard parts, we have details with internal coding), failed the relationships rightly I find myself 2 connecting rings, I do not press anything or save nothing, I do "nail" by button but it is gray and therefore I have to go out without saving (or reestablish the piece with the correct one).

Premute that on solid edge/general options an increase in part and assembly is set to 10

Same as the draft. I erased a quoted view, I realized I did the stupidity that was not what I had to cancel, but nothing to do, the "nothing" are not there, eh si che anche qua sono set a 10.

By the way, I have now made a test on an assembly and replacing a particular with another does not ask me for any confirmation.