alberto64
Guest
Good morning, I have a simple problem...; I get a set from an external collaborator, so a pack'ngo, obviously the bolt does not match the custom one in the toolbox with code part. how can I replace it with a toolbox component?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
meccanicamg
Guest
completely eliminate the use of toolboxes. use custom bookcases, because so you omine all problems. Unfortunately, it is more than a decade that we try not to use them for these reasons.
re_solidworks
Guest
I took the same conclusions and made the same decision.completely eliminate the use of toolboxes. use custom bookcases, because so you omine all problems. Unfortunately, it is more than a decade that we try not to use them for these reasons.
MassiVonWeizen
Guest
if you interface with other developers you have to have the same configurations: models, libraries, working standards.
therefore if you personalize the parameters must be communicated and delivered to the subordinates.
Try to think if you lose half a day to replace the toolboxes and then you get a review? And then another... to me it happened and I threw away entire days that then I had to justify to the owner.
the best thing is to use a custom library, even toolbox for how bad it is for a thousand reasons, and organized to give the various collaborators.
for your specific question from what I remember when making the pack&go you can disable the inclusion of the toolboxes. check and send back files from the collaborator. otherwise you have to change references one at a time
therefore if you personalize the parameters must be communicated and delivered to the subordinates.
Try to think if you lose half a day to replace the toolboxes and then you get a review? And then another... to me it happened and I threw away entire days that then I had to justify to the owner.
the best thing is to use a custom library, even toolbox for how bad it is for a thousand reasons, and organized to give the various collaborators.
for your specific question from what I remember when making the pack&go you can disable the inclusion of the toolboxes. check and send back files from the collaborator. otherwise you have to change references one at a time
Last edited: