components section for church

[M.M.3D]

Hello everyone, I have just written and I have a question to ask you.
I am about to end the reconstruction, through revit, of a church of pavia. I reassembled everything through components (walls, columns, frames, etc.), but I have problems with frames created with extrusion on path.
in a few words I can not dissect them; in the section pane in the 3d view disappears and in the section views are not dissected, appear only perspectives.

I attach images to make you understand better.

thank you so much in advance of your help

 

[Tristan]

without knowing how they were created and without having the file under hand we can only guess. . .

 

[M.M.3D]

Okay. can I eat bird? will I send you via mail?

 

[Tristan]

Can't tie him here in the discussion?

 

[M.M.3D]

Unfortunately not, I tried also to zip it but it does not take me

 

[M.M.3D]

if your msn contact is valid I send you the file by email. I still expect your consent of course

 

[Alfredo Medina]

... but I have problems with frames created with extrusion on the path.
in a few words I can not dissect them; ...

And how did you get the frames? Maybe they did it in a category that you can't cut, you have to change the category to another that if you can cut, like walls.

 

[Tristan]

if your msn contact is valid I send you the file...

you are still valid

 

[M.M.3D]

And how did you get the frames? Maybe they did it in a category that you can't cut, you have to change the category to another that if you can cut, like walls.

That's exactly why.
going to review the parameters of the mist I had set up as category "context". as soon as I replaced it with "comforts" and then "muri" immediately dissected me

Thank you very much:redface: