cone development tracking lines

[MARCOC]

hi Masses...as I have already written I have not found solution on the calandrates, so I could not in any way update you beyond, if I did not repeat that I did not find solution...but if you succeeded you could post the solution

 

[MassiVonWeizen]

bhè a solution, rather coarse, I had already put it to post #13.
the most elegant one is that of the file; it goes as if to be included in the development can not be a simple sketch, but a cutting function must be made

 

[MARCOC]

that solution unfortunately is not good, as the tracking line has to be unique, I cannot export dxf to which I have to put my hand to adjust and delete lines unfortunately
amen this type of work I will continue to do with other programs, perhaps on future versions of solid will implement it, let's say that the part of solid sheet in my opinion should be a little updated he lacks some fundamental shortcomings for the management of the laminaires

hi Masses good day

 

[MassiVonWeizen]

that solution unfortunately is not good, as the tracking line has to be unique, I cannot export dxf to which I have to put my hand to adjust and delete lines unfortunately

If you said that before, I would have told you that it was impossible.

 

[MARCOC]

the result must be that on the flat model I have to have sketch lines which are traced on the model[/QUOT

 

[MassiVonWeizen]

My fault.