configuration and display status: aid

[reggio]

ciao, ho un together which represents an electric box, I must create
monophase configuration - monophase version with some blue color surfaces - display status: monophase
configuration - three-phase version with some red color surfaces - display status: three-phase
I watched the video of prampolini and others on the net but with my sw16 I couldn't "bind" the monophase configuration with the display status: monophase and three-phase with three-phase...

configuration change but the colors remain those and the display status does not follow me ...

Do you want to give me 2 straights and guide me on how to make sure that with some red surfaces are related to the three-phase configuration and the three-phase display status?

 

[MassiVonWeizen]

have you tried to create the states of visuialization in the parts and recall them in the specific configurations of the ashem?

 

[reggio]

have you tried to create the states of visuialization in the parts and recall them in the specific configurations of the ashem?

Thanks massive ... but at that point ... instead of working with only the colors, so much so that in the axieme I go to mount both the blue monophase plug and the red threephase and then I confiscate the suspension of one or the other in config together

... to solve the flight I did so, but ... I'm sorry I didn't once again fail to understand how the devil uses the visualization states... sob ...

 

[MassiVonWeizen]

, so much so that in the axieme I go to mount both the blue monophase plug and the red three-phase

instead of having two parts with relative couplings, is it not easier to have one part only with a single configuration and with two display states?