configuration conflicts, equations

[Turambar]

Hello everyone, I have a problem that concerns me about solidworks configurations. I built a panel framed with "c" sheet metal. the frame is composed as I said by "c" in sheet, in fact it is only one c with 2 configurations where only the length changes. I configured in a set through equations the inner panel, the panel height should correspond to c1, and the width to c2; but being the same quota even if on different configurations, the c becomes equal and I lose the initial configurations, which are restored if I eliminate the equation. I also tried with variables but nothing, same thing. I hope that I have been clear in exposing the problem, I thank in advance those who will provide me with your help. Thank you.

 

[MassiVonWeizen]

You put the same quota twice, one I will be obviously driven, and in the different configurations you suspend one or the other

 

[MassiVonWeizen]

Here is an example of what I mean.
as you see in the photo attached there are, in the same sketch, two quotas on the same entity; One is piloted and the other is active.
changing configuration the state is reversed
View attachment quote configurazioni.zip

 

[Turambar]

Thank you so much! alone I wouldn't have arrived. It works perfectly, thanks again.