conical gear

[usamx7]

I have a problem in generating a conical toothed wheel with desing accelerator, with inventor. by entering my data (module, z1, z2, pressure angle, ) the width of the tooth b is limited. or, according to my module 4, the b can not exceed 32.2 mm. If I put m = 5, the limit rises.
Now, I know from school studies that b is equal to 10 times the module. Here you go, m=4, b=40.
Thank you in advance, hello to all!:finger:

 

[stefanobruno]

I use little or nothing des. acc. and the other week I generated a sprocket to teeth rights m3.
This was 20 mm wide and not 30 mm wide, must we begin to worry?
or the [ b = 10 x m ] not valid in self-desk-use (there will use space materials )

Bye.

 

[usamx7]

the fact is with the toothed wheels straight the value of b, you can set it, while in the cones is bound by preset parameters. thanks to the same answer:wink:

 

[diegus]

remember that autodesk does not ensure the correctness of the wheels that generates, in the sense that the wheels generated from the from cannot, for example, be sent to a cnc for the realization of the same. are purely descriptive!