cen82
Guest
I've been trying to get into this. In practice, I have a trapeze that represents the area I have to cover, in my case a ceiling.
This ceiling is made of sheet metal panels with the same processing and change only for the main face that will be, always rectangular, but adapted to the trapeze area where it will be mounted. I have so far used or iparts, but today I have put myself in my head to do all this with icopy. It's a command I've never deepened, but I think it's suitable for this case, right?
I did some evidence but I can't create the series. Does anyone help me?
That's how I moved.
-I'll take a part.
- I believe a rectangular sketch
-creo two points and beat the fixed panel measurement
- making adaptive points except one
-Scancello the sketch
-I'm a sketch projecting the two points and binding them to my rectangle
- I make my face adaptive.
I save and put it all in an empty set.
is it correct?
This ceiling is made of sheet metal panels with the same processing and change only for the main face that will be, always rectangular, but adapted to the trapeze area where it will be mounted. I have so far used or iparts, but today I have put myself in my head to do all this with icopy. It's a command I've never deepened, but I think it's suitable for this case, right?
I did some evidence but I can't create the series. Does anyone help me?
That's how I moved.
-I'll take a part.
- I believe a rectangular sketch
-creo two points and beat the fixed panel measurement
- making adaptive points except one
-Scancello the sketch
-I'm a sketch projecting the two points and binding them to my rectangle
- I make my face adaptive.
I save and put it all in an empty set.
is it correct?
