GTI
Guest
Hello everyone,
I'm learning to use the module dmu kinematics catia simulator v5 from self-taught.
I find myself having a set consisting of a solid tree with a toothed wheel and a crank
that allows to put it in rotation. the shaft turns on two ball bearings
molded as a subaxieme and previously simulated as a mechanism. once the mechanisms have been imported
of the bearings as secondary mechanisms, I would like to put them to the tree so that acting on the handle can also simulate the movement of the
bearings.
So my question is: is there a way to connect two or more mechanisms?
Thank you very much.
he's doing it.
I'm learning to use the module dmu kinematics catia simulator v5 from self-taught.
I find myself having a set consisting of a solid tree with a toothed wheel and a crank
that allows to put it in rotation. the shaft turns on two ball bearings
molded as a subaxieme and previously simulated as a mechanism. once the mechanisms have been imported
of the bearings as secondary mechanisms, I would like to put them to the tree so that acting on the handle can also simulate the movement of the
bearings.
So my question is: is there a way to connect two or more mechanisms?
Thank you very much.
he's doing it.