connected lines considered as the only entity in moving

[MaiMollare]

Good day to all
are a proengineer user who due to force majeure is forced to return after years to the good old autocad.
I found a very annoying problem that I can't fix:
If for example I prolong one line on another perpendicularly, and then I try to move it, autocad considers them as a unique entity and moves them together as if it were a block.
this problem matches it for each length line circle etc.
I also tried to use the grip but same speech.
Is there any secluded variable I don't remember anymore?
thanks for your help

 

[Tristan]

version of autocad?

 

[MaiMollare]

hi sorry the delay, big problems with the net
the release is autocad 2009

 

[Tristan]

hi sorry the delay, big problems with the net
the release is autocad 2009

sure it's 2009? not 2010 or sup.?

 

[MaiMollare]

you're right I checked, it was updated, and it went from autocad 2009 to autocad mechanical 2011

 

[Tristan]

you're right I checked, it was updated, and it went from autocad 2009 to autocad mechanical 2011

ah here... then look at this link
http://exchange.autodesk.com/autoca...s73099cc142f48755-1257e12111bf108800e3e06.htmthe command you need is elimvinc

 

[MaiMollare]

Thank you so much I pulled out the command and now it all works properly