connection walls - roofs

[iwaz]

hi guys, I'm new and very newbo with revit...

probably and a sad and retrite topic I looked everywhere, tried everything but I can't...I open a new thread on this topic because I tried all . .

I attach the photo of what happens to me
with the commando associate/base I can not lift the wall until the height of the roof, gives me an error message "impossible to maintain wall and goal united". I can lift those 15-year-olds... only the 30-year-olds...

I also tried the solution to remove a portion of the wall by lifting it over the roof but zero, I can not use well the empty function.. .

possible that such a simple thing requires all these complicated turns? How can I solve this? Thanks bye

 

[gfrank]

without seeing the file it is difficult to understand its cause.
In general, for the wall concerned, try:
- to use the "dissocia" command to verify that there are no other "unions"
- verify that the wall in question has not been edited with the command "change profile" at the top

try also to use a different type of wall (other type) : if it works, use the new type of wall, rename and change materials and thicknesses of the new type

 

[iwaz]

Hello gfrank, thank you for the answer.. .

I tried to dissociate, delete the walls from 30 generics and put them back from scratch... but nothing
I tried to delete them and replace them with 15 walls, but nothing...that error message remains. . .

Boh. .

 

[iwaz]

place the link of a test file I created from scratch, to show you the situation you create
http://www.filedropper.com/prova_14the piantine e questa
if the roof leaves it as well, the outer walls do not hook, if instead than leaning the roof in half-pillar support the bonfires in the edges of the pillar (indicated with the arrow) it hooks.. .

 

[Tristan]

apart from that I don't understand the usefulness of a roof made like that...anywhere controls the joints of the walls: if your wall has come to the corner on both sides should be able to associate it

 

[iwaz]

the walls of the quadrilateral have arrived but it does not make me associate them to the height of the falde...while to the height of the pillars...

If I disjoin them, I'll get them together... see below

 

[iwaz]

thanks tristan, I read your post in a hurry, you were right, I solved by joining the corner walls, sorry but I did not know the existence of that option :biggrin:

 

[gfrank]

Well, it's settled.

I invite you to attach the images, through the command "go to the advanced mode" and to use the procedure "manage attachments" to attach the images.

 

[Squello]

Good morning, everyone! I am also new, I apologize, but I have not been able to find the section on the presentations...... I am accusing to this discussion because I also have the same problem, I place an image:As you can see, until a certain point the continuous facades have associated with the cover, which said incidentally, is a roof generated by a solid coming from rhino, then others are not: they are those that overlap to the cover.... would you have idea what the problem can be? ? ?

 

[gfrank]

... considering that the problem is "only" on the cover part, it is possible that the problems are consequence of the imported solid from rhino . try to make a piece of roof generated directly from revit and see if the problems persist ...

 

[Squello]

Okay thank you!! I try now and then I let you know... .

 

[Squello]

The problem is solved! the strange thing is that it seems to give problems only along the edge and not with the walls inside....mah!! at this point the only solution I think is to edit the profile of the panels one by one.....