coordinated extraction of points on curve

[BerAnd]

Hello everyone
cad veration used: wf3 m180

I have a sketch curve that I use to then perform a cut (style cam channel to mean us), on this curve I go to create a point, then I send it in series.
that you know it is possible to extrapolate in a text file (or other formats, no matter!) the coordinates of each individual point compared to a coordinate system or any point (father point of the series?) of the part without using mechanism?

thanks to all
Good day

 

[Prof.]

Make a sketch table. After that you can use the tool table holes found under tools > table holes.
besides with holes it also works with axles and points, it creates a table with coordinates compared to the reference system.
such table you can then export it as text file.
Bye.

 

[SweptBlend]

I think it goes to remember a different solution, export igs, export dxf only points, passage from excel, but in the end the quickest solution is effectively the one suggested by prof.

 

[BerAnd]

I thank you both... but the Igs is a great idea!
then just pass it to pts and use it as a file to create a cloud of points.
I tried both of them and they both went very well. . .

Thanks again
Hi.

 

[vinz72]

Good morning to all
I use the wf 2.0

I have the opposite problem, I explain better:
I have a set of points contained in a txt text file and I would like these to be imported and merged into a spline within a sketch.

thanks in advance
♪

 

[BerAnd]

you have to create a curve from ibl by putting as header the following strings:

open
arc length
begin section! 1
begin curved

once you're under, only the coordinates must remain.

then curved command -> from file -> etc.

Hi.

 

[vinz72]

It's working!

I would add a clarification as indicated "folle76":

save the excel file as .txt excretion text
check that the points are like this:

1 3.4 1
2 34 4
1 1111 1

a point for each row with coordinates separated from at least one space

thanks to all and good make!