copy and incollection

[Beppe]

Good morning
I can't figure out how I can report the same details in different designs with inventor 2015?
copy and then paste do not do this function
Thank you.

 

[TECNOMODEL]

Tables? Assign me?

try to be clearer. . .

 

[Beppe]

I actually have both inventor lt but 2011 and inventor 2015 and I'm exercising to draw coils and in front of the reel there are attacks for connectors, the attacks are equal for all kinds of connectors, so designed the body I would like to insert these attacks.
with inventor 2015 now thinking about having understood, but with lt (I know it doesn't make assemblies) how can I do the job I described before?
Thanks I hope I've been a little clear

 

[TECNOMODEL]

The attacks are part of a single body or are separate bodies, and so you set them up as a set?
If they're separate parts, I don't see the problem together.
you can also make a series, circular or rectangular, so you have repeats at defined distances.

If it's a single part you can create i-features and put them wherever you want.

 

[Beppe]

Thank you
you are clear

 

[stefanobruno]

copy and paste the processing from the browser.
It is not very simple because you must indicate the correct plans and references, corresponding to those of the piece father.
you can also do it in later steps, respecting the original sequence.

 

[Beppe]

stefanobruno I can not always understand using i-features

 

[stefanobruno]

stefanobruno I can not always understand using i-features

I know that there are i-features but I never used them, I don't know what they can do.
I mean you can go to the processing tree and copy some of it and then paste it into a different ipt.
maintain the possibility of being parameterized and further manipulated.
this system allows you not to repeat sketches and processes one by one but to reuse a tot. inserting them in a model different from the original.

 

[Catafratto]

I know that there are i-features but I never used them, I don't know what they can do.
I mean you can go to the processing tree and copy some of it and then paste it into a different ipt.
maintain the possibility of being parameterized and further manipulated.
this system allows you not to repeat sketches and processes one by one but to reuse a tot. inserting them in a model different from the original.

I thank you for the suggestion!

 

[gymbg]

I also copy and take off the browser

 

[Beppe]

Good morning
Now I understand what stefanobruno said, of precise references, the two details must be exactly in the same position.
Thank you