corner structural members

[Tantocattivo]

Hello.
I have a problem with angled structural members with equal rounded sides. I attach a frame of a bag made with the above profiles. the problem lies in the treatment of edges that I cannot do as I want, in fact or I have to do so many shortness element (although it does not make me do it in everyone as in the annex) or it extrudes me also the internal connection of the two sides. cmq if you open the design and look you understand better than I mean:biggrin:

 

[Mike1967]

Hello.
I have a problem with angled structural members with equal rounded sides. I attach a frame of a bag made with the above profiles. the problem lies in the treatment of edges that I cannot do as I want, in fact or I have to do so many shortness element (although it does not make me do it in everyone as in the annex) or it extrudes me also the internal connection of the two sides. cmq if you open the design and look you understand better than I mean:biggrin:

apart from the links I would have made them with a new structural mermaid,
it is possible to cut the above pz in one step.
Unfortunately the internal radius and the net edge at the intersection create
That problem.

 

[Tantocattivo]

apart from the links I would have made them with a new structural mermaid,
it is possible to cut the above pz in one step.
Unfortunately the internal radius and the net edge at the intersection create
That problem.

thanks to the celerity and also the video.
I did as in the video and I could get there too :tongue: and I also lost a lot of time, including about the tutorial of the structural members. Now I do the tests by doing different structural embryos, but so on two feet I see that it doesn't change much.

 

[Mike1967]

thanks to the celerity and also the video.
I did as in the video and I could get there too :tongue: and I also lost a lot of time, including about the tutorial of the structural members. Now I do the tests by making different structural embryos, but so on two feet I see it doesn't change much.

Yes, at the level of shoulders/cuts no, but in case of changes it is more manageable, all there.
put that instead of the angle to make the connection you want to put a frame tube....

 

[Tantocattivo]

Okay, I didn't take this chance into consideration because I know it will never be like this in my case. cmq true, you can not change the profile of one group.

Thanks