crash inventor during thread application

[mdbosca]

Hi.
happens to you the lock and subsequent closing of iv2010 (every much) when applying the thread in an extruded pin? every now and then it happens that even by doing the hole, once you select the click point the option "bed" below and here it freezes.
all this happens after the upgrade to sp2.

 

[Tarkus]

Hi.
happens to you the lock and subsequent closing of iv2010 (every much) when applying the thread in an extruded pin? every now and then it happens that even by doing the hole, once you select the click point the option "bed" below and here it freezes.
all this happens after the upgrade to sp2.

No, but he doesn't miss the chances of crashing.
to me for example, sometimes it doesn't make me edit a share in sketch, and at the third attempt it goes to be blessed, but reopening it works correctly, I don't even send the report to autodesk anymore, so....

 

[vale79]

Hi.
to me with the holes never happened, with the threads always!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! and especially if you didn't save just before filet. I noticed that if you click on the command and then immediately on the surface to file, before the dialog box appeared, while if you click on the command, wait a few seconds the window and load the table and then select the surface you have some chances that don't crash.
Bye!
valet

 

[Ilario]

never happened, and with 2010 if crash once a month is so much.. .

 

[Avoplus]

never even happened to me (not with 2009, nor with 2010).
(I happen that the threads represent her as crap, but without crash! :wink