create simulated forces application surfaces 2016

[Disgra93]

Hello, everyone! I'm new to simulated solidworks and I just can't do this:

on my solid there are loaded areas and areas that are not on the same surface.
How can I isolate an area on which force acts? normally the software allows me to select only the entire surface.

Thank you!

 

[MassiVonWeizen]

I don't know simulated, but I think if you create surfaces above the existing one, you should be in place in the affected areas.

 

[New Rider]

Hello, everyone! I'm new to simulated solidworks and I just can't do this:

on my solid there are loaded areas and areas that are not on the same surface.
How can I isolate an area on which force acts? normally the software allows me to select only the entire surface.

Thank you!

Hi.

You need to create a split line on your face.
take the piece you need to analyze > I would sketch an area under the load/wine> division line by selecting the sketch and face.
In this way you create specific areas where you apply loads and constraints.
Hi.