created gauge table

[cccicccio]

good afternoon to all
I have been working in the world of sheet metals for years and have experimentally obtained the value of the k factor and the internal radius for each material, thickness and torque lama-matrice used in bending.
I would like to make sure that when you set the sheet you can load a table in which you can select the quarry, the thickness and then load the reference k factor.

How can I create such a table?

Thank you in advance.

 

[MassiVonWeizen]

when you cri the sheet you have the option to use the bending tables. Put one on it and flip it through. see where there are those standards of solidworks and studies or change those concerning the k factor
typically located under installation/lang/italian/sheet metal gauge tables