creo4 avoid parameters

[french]

Hi.
I would like to know if you can perform a job together by eliminating the parameterity so that you avoid
to regenerate by blocking features like copying surfaces that I would need unscrew.
Thank you.

 

[320i S]

when you make the surface copy together, there is in the options, the manual regenerate instead of automatic, or the total release.
eye to the total disgrace, because it should not be able to go back again.

but this is only for copy geometry, the mere "copy-paste", does not have this manual update option.
would not be the appropriate command "copy-paste" in the case of copying geometries together.