curved coating gallery

[phantomas]

Hello everyone,
I have a problem that I can't find yet another answer:
briefly:
I have a circular section gallery, to this I have to place a covering of curved panels (which then follow the curvature of the gallery) attached to a system of mounts (also these curves).

advice?

Until now I have tried to act by building the mass of the gallery, and trying to apply a "screen system" (not a curtain wall, it does not allow me). problem: the curtain system breaks me the curve creating rigid panels, as well as breaks the mounts (even these should be curved). the mounts are "omega" sections ordered with a curved date.

thanks to those who wanted to help me!

Say hello!

 

[Alfredo Medina]

I think this is possible. It takes a special panel, with a controlled curve for a radio parameter. If you know the radio of the gallery, you could do a shared superficiety that uses this panel as a reason. it would be the same as having a polygon of many vertices inscribed in an arc or a circle.

 

[Tristan]

with a controlled curve for a parameter radio. If you know radio de la gallery

only for your cold knowledge. the translation of "radius" in Italian is radius

 

[Alfredo Medina]

Thank you, Tristan, many thanks. I often mistake with Italian.
radius, radius, radius, I'm learning... :smile: