curved surface opening + projection

[ericaferrara95]

Good morning.

I would need your help, needed to "open" a hug of a bracket of about 30 degrees and to bring back on it the path of the same sunbed. for the first passage I would say that I arrived, through sketch and geometric construction, we accept obviously proposals and advice; I miss the second part on how to project the asolathanks for the collaboration!

 

[ericaferrara95]

Grazie!

 

[ceschi1959]

ciao @ericaferrara95 ,

I'm gonna walk you through the step with nx.
as I did:
I 'beared' the two surfaces with a command called flattening and (forming), projected the asolar on the surface to be asolar and then reused the previous command with the (flattening) and forming 'reforming' the surface to be asolar. then I gave it all thick.
p.s. if catia has a similar command it takes about two minutes.

Hello there.

 

[Vittorio]

ciao @ericaferrara95with catia you can do but you have to have the gsd module (advanced surfaces)
with that module there is the possibility to flatten one surface and to project it on another
shape

 

[ericaferrara95]

ciao @ericaferrara95with catia you can do but you have to have the gsd module (advanced surfaces)
with that module there is the possibility to flatten one surface and to project it on another
shape

Hello, thank you, alternatively?

 

[ericaferrara95]

ciao @ericaferrara95with catia you can do but you have to have the gsd module (advanced surfaces)
with that module there is the possibility to flatten one surface and to project it on another
shape

Hello, thank you, alternatively?

ciao @ericaferrara95with catia you can do but you have to have the gsd module (advanced surfaces)
with that module there is the possibility to flatten one surface and to project it on another
shape

Are you talking about this form?

 

[Vittorio]

not enough
in its interior of generative shape design there are other commands for gsd