Antodima77
Guest
good evening to all I am new my name antonio I am a designer and use inventor.
in the specific situation I am using the 2015 version.
my client sends out step to the manufacturer the plates to be made where there are a series of processing including holes m8 .
the problem is that inventor as a metric thread hole gives me about 6.64 and not 6.75 as a rule for metric thread, but above the issues normally I wanted to ask if someone knew how to change the parameters of the holes.
I tried with the thread table that handles the holes but I would like to know if someone knew the values to assign in table to have a 6.8 hole for m8 thread.
I did a search on the forum but I couldn't find anything, thank you in advance
antonio
in the specific situation I am using the 2015 version.
my client sends out step to the manufacturer the plates to be made where there are a series of processing including holes m8 .
the problem is that inventor as a metric thread hole gives me about 6.64 and not 6.75 as a rule for metric thread, but above the issues normally I wanted to ask if someone knew how to change the parameters of the holes.
I tried with the thread table that handles the holes but I would like to know if someone knew the values to assign in table to have a 6.8 hole for m8 thread.
I did a search on the forum but I couldn't find anything, thank you in advance
antonio