& Custom Props Library Material

[andrea.boerio]

Good day.
exists a way to recall, among the custom properties, the yield load (so to say), contained between the properties of a material, obviously place that the material was assigned to model 3d?
I have seen that you can easily recall the name of the material, I would like to send to a table in the drawing also a small selection of mechanical characteristics of reference.
Hi.
a.

 

[SolidUser]

No, only through bees.

 

[andrea.boerio]

No, only through bees.

ok, then if it becomes a necessity I solve it in visual basic, I insert the reading of the data in a routine for compiling the properties.

Thanks, bye.
a.

p.
They start to be a bit, the coffee I owe you.:wink: