custom section handles

[vitorifi]

Hello everyone

I would like to know if there is a possibility to create a custom section hold.

Thank you.

 

[ferrezio]

I have modified the hold properties, or create a custom material where you specify your holding properties.

Hi.

 

[vitorifi]

but I need a totally different type of restraint from existing ones, I don't need to change existing ones.

 

[ferrezio]

You don't need to write to capital letters, it's more accurate when you ask the question.

specifies the tracing careers, (if it is a restraint).
is it a sampling?
a filling?
is it part of the regulations?
do you know all the possibilities of modifying the properties of a restraint?
do you know how to create custom materials?

Hi.

 

[vitorifi]

the writing in capital is only as there was the key of the locking capital not for anything else.
However, I need a type of sampling different from the standard casket, if it is possible to create it also through the drawing itself for example and then use it as a sampling.

Thank you.

 

[ferrezio]

you have to start the catia administrator session and edit one (or create a new one) of the files that define the standards in the "repetition" item.

Hi.

 

[vitorifi]

where do I find standard files? ?

 

[Mocca]

in this forum you are not on nobody's payroll; who helps it please and not by necessity or obligation. ferrezio has already been, in my opinion, excessively courteous and available to help who, always in my opinion, did not place properly in asking for information.
I usually don't answer who "books" answers.
we waved