customization board board inventor 2011

[Fabio Colletta]

Hello.

customization board tables:
I have a problem with customizing the board on inventor 2011.
I would like to parameterize quotas with respect to the height and width of a
sheet, then of the odds that change to the range of the format a3-a2...etc. .

the problem and that if you put the quotas height and width sheet within the creation of the new edge, you have to put them not parametric, because the quotas could "pervine the sketch", and this is good for me...
when I go to parameterize a quota by inserting in the formula the non-parametric quota takes it without problems, if I go out and return from the definition of the board the two quotas became purple and send me in banana the custom board.

Does anyone have a solution? ? ?
I attach a file for greater clarity.

p.s. I can't create instances with the inventor's command but I have to create them manually... Don't ask me why... that's it.

 

[MBT]

Um...
a nice bill, which however arrived you via pm and also via email, would like the new arrivals to pass to present themselves in the area ot or in the discussions present in each section :wink:

Don't ask me why... it's like this!

 

[Fabio Colletta]

I apologize for violating the rules.
What is the area? ? I can't find her.

Thank you.

 

[Sandra_ME30]

I apologize for violating the rules.
What is the area? ? I can't find her.

Thank you.

ot = off topics
sezione che trovi qui:http://www.cad3d.it/forum1/forumdisplay.php?f=30:smile: