cut the falde_pennacchi

[juliettins]

Hello, everyone!

new. .
I've been practicing for a while on archicad..

I created a dome and three barrel vaults that however must be connected to the central dome. .
I created a dome spike like a pen, but I can't cut it. .

How to cut the bonfires? ? ? possible that with the command cut with the bonfires you can not cut also the bonfires between them?

giulia

 

[DarthVader]

the bonfires cut like all other elements or with the tool "cut" (ctrl+clic) associated with a director

 

[juliettins]

the bonfires cut like all other elements or with the tool "cut" (ctrl+clic) associated with a director

Bye!
Thanks for the answer.. I immediately tried but with ctrl+clic I can not cut. .
Are you sure they can cut the bonfires, and not just beams?
I'm afraid you can't do it as with the command cut with the bonfires. .
I'm desperate.

If not, it's me. Do I have to use a special way with the Governor?

 

[DarthVader]

in 3d is much more complicated. in 2d just put a line, select the layer to cut, ctrl+click and indicate the line.
if you want to do it in 3d, I would use in your place the operations with solid elements, found in the menu "design"

 

[juliettins]

in 3d is much more complicated. in 2d just put a line, select the layer to cut, ctrl+click and indicate the line.
if you want to do it in 3d, I would use in your place the operations with solid elements, found in the menu "design"

Thank you, I'm trying. .
Sometimes it comes, sometimes it separates me from the ground, but it does not eliminate the part that I would like to be taken away. .
and read it as the only element cmq..

 

[DarthVader]

excuse me, however, instead of with size, use divids (the symbol with the axe) and separate the flap in 2 and then eliminate the extra one. I had responded to you without the programme before and apparently I was not very fit;-)

 

[juliettins]

excuse me, however, instead of with size, use divids (the symbol with the axe) and separate the flap in 2 and then eliminate the extra one. I had responded to you without the programme before and apparently I was not very fit;-)

Bye!
thanks for the operation command with solids,
but how do I cut a part of a barrel vault?

I mean, from one time to another I have to do a barrel profile to simulate the stucco. .
I'll get you an image if I can. .

Thank you.

 

[DarthVader]

I don't understand what you need, do you have an image to show the result you have to get?

 

[juliettins]

I'm pretty much supposed to do a mini-time fight. .
thinner.. a profile. .

I wanted to cut the time I had already created and lower it, the problem is with operation with solids I can not cut it, because if I gate in the wall with which the cut restores all the time. .

 

[DarthVader]

for this you should use complex profiles