roccolaser
Guest
hello to all I have a problem can I make a cut that intersects a cone-shaped surface? I attach a file to better understand my problem maybe I explain bad...
marcof
Guest
secertochelopuoifare. . .
PiegatoreSolidworks
Guest
I think you didn't post the file well...hello to all I have a problem can I make a cut that intersects a cone-shaped surface? I attach a file to better understand my problem maybe I explain bad...
do "pack & go", however I confirm that it is very feasible!
marcof
Guest
in that word-phrase you should not be grasped my irony:wink:
PiegatoreSolidworks
Guest
In fact maybe you're right, I'm very tired...
biggrin:Mike1967
Guest
. by force: write in "Crittograph narrow".... :biggrin:
marcof
Guest
I could (but in these cases I should, and maybe I will have to...
) write in "rullocompressorese" extended, but then break the marons. :wink:roccolaser
Guest
Hello to all I have made a pack and go I attach the file again....:frown:
marcof
Guest
I imagine (so as not to lose the habit to do it
) that you wanted to cut the foot... but maybe it was too simple and I didn't guess.Mike1967
Guest
Did you lubricate and polish the glass ball? :biggrin:I imagine (so as not to lose the habit to do it
marcof
Guest
But look, I don't think it's worth it.
I don't know how you are, but I have customers out of the tent who still go complain because you point out that the forecasts, free, you do them with esoteric tools.
in the circus world you never take... I almost enlisted as an apprentice of lions, which is less risky. :smile:
roccolaser
Guest
just a little bit of attention, you're right but I thank you very much :finger: