data table and profile lengths

[Stexxx79]

hi to all, use solidworks for a few years but I never managed to solve the following problem:

I created a library of parts and derivatives of pipes. the pipes were created with the extrusion command. to the extrusion length was linked the property length.

once you have created the axieme with the pipes when I am in the table to recall the data table, where there are the lengths of the various tubes I see, that the measurements are all the same according to the last profile of the pipes that maybe was previously opened to add a new configuration. :confused

you would help me solve this annoying problem to have a right and automatic pipe cut distinct.


Thank you.

 

[geppetto]

hi to all, use solidworks for a few years but I never managed to solve the following problem:

I created a library of parts and derivatives of pipes. the pipes were created with the extrusion command. to the extrusion length was linked the property length.

once you have created the axieme with the pipes when I am in the table to recall the data table, where there are the lengths of the various tubes I see, that the measurements are all the same according to the last profile of the pipes that maybe was previously opened to add a new configuration. :confused

you would help me solve this annoying problem to have a right and automatic pipe cut distinct.

Thank you.

I don't understand. the length of the various tubes you insert is given by all different parts or are different configurations of the same part?
are all different parts the problem should not exist or I did not understand the problem, but if the part is the same and put together the different configurations the program should give you both the name of the config. that the different given on the length.
Ooops... but insert a data table or a separate material? because my example refers to a distinct and not to a table (I should try with the table... )

 

[Stexxx79]

the file part of the pipes to various independent configurations between them as the pipe can be of different sizes (diameter) and to each diameter or configurations derived to distinguish the various lengths.
i.e.

2" tube and derived configurations type 100,200,300 to distinguish tube lengths from 2".

3" tube and derived configurations type 100,200,300 to distinguish tube lengths from 3".

so on.

the table I insert is a material table where I tied a column length to the value connected to the extrusion quota of the tube.

 

[meccanicamg]

If you put the property in the individual configuration custom property tab, you have to force the right length of each individual configuration. if it is not so there is some problem or in the model or version of swx