decal or similar

[Daniele-san]

Good morning.
I've been looking through the various discussions but I couldn't find what I needed.
in a set I have some parts (mechanically equal) used several times but with different silkscreen.
serigraphy files were created with ai.
How can I see these parts in the axieme with their serigraphies?
I tried by adding a decal but the result is that all the equal parts have the same "image" and the decal apparently is not manageable directly with family table
Can you help me?
Thank you.
Good job

 

[freexf]

the decal in question add it to level asm and not part.

 

[Daniele-san]

the decal in question add it to level asm and not part.

until now I did it at prt level
I didn't try

 

[mamobono]

Hi.
I do this but I have the module advance assembly.
amount in another prt with inheritance function the basic piece and I put silkscreen 1
and proceed in the same way to others.
In this way I have a piece for every serigraphy as in reality but also the advantage that the basic piece is the same and in case of automatic revision (depending on the modification and serigraphy where it is put obviously) it updates everything .

Hi.

 

[Shotfree]

I agree with you @freexf , you must apply the material to the parts together and not directly to the parts, so each detail will have its visible decal.