decals in the assemblies

[19marco77]

Hello, everyone. are new (both in the forum and with sw [nonchè autodidatta]).

I have tried to find out if among other discussions had already been talked about the problem I currently have without results.

at the completion of a set I would need to apply the decals on various parts.
I can't do it directly on the part because the positions vary according to the project I'm doing.
the problem is that by applying the decal in the axieme it does not let me select the surface but select the whole part.
In this way the decal applies to me in the right place but it also appears to me in the opposite side.

Can anyone help me?

Thank you. Mar

 

[Ivan1990]

Hello, everyone. are new (both in the forum and with sw [nonchè autodidatta]).

I have tried to find out if among other discussions had already been talked about the problem I currently have without results.

at the completion of a set I would need to apply the decals on various parts.
I can't do it directly on the part because the positions vary according to the project I'm doing.
the problem is that by applying the decal in the axieme it does not let me select the surface but select the whole part.
In this way the decal applies to me in the right place but it also appears to me in the opposite side.

Can anyone help me?

Thank you. Mar

I recommend you submit yourself in the appropriate section written in the regulation, which should be read.
said this, to avoid this problem you have to open the part where you want to apply the images, then insert the decal, and in mapping you can decide how to insert it, whether on the face or on the body, etc.... In theory if you apply it on the side should already of defoult put it on the face.

 

[19marco77]

I recommend you submit yourself in the appropriate section written in the regulation, which should be read.
said this, to avoid this problem you have to open the part where you want to apply the images, then insert the decal, and in mapping you can decide how to insert it, whether on the face or on the body, etc.... In theory if you apply it on the side should already of defoult put it on the face.

Thank you ivan. I will make presentations

My problem is that on the same side I might have the need to apply some decals that will not have to be present in all assemblies. Now I see if it is possible to exclude the various decals from the display tree within the axieme. Thank you for your help. :finger:

 

[Ivan1990]

Thank you ivan. I will make presentations

My problem is that on the same side I might have the need to apply some decals that will not have to be present in all assemblies. Now I see if it is possible to exclude the various decals from the display tree within the axieme. Thank you for your help. :finger:

Just as long as you don't want them to hide...

 

[eboss]

or create configurations on the parts where on each active the desired decal, and on the axieme impose the configuration you need.

 

[19marco77]

or create configurations on the parts where on each active the desired decal, and on the axieme impose the configuration you need.

:d right also this proposal...
of the series.. What do you want? Hi.

Thank you.

 

[SolidUser]

My advice is another.
create a fictitious part in the axieme known by the name of 'virtual component'.
change the axieme and extract the surfaces of the components on which you will apply the decal and then apply it.
the component can be excluded from the bom.