definition curved lines

[render54]

I'm building a line of bathroom accessories.
soap dish, cup holder, hanger holder etc.
objects are small so I find some difficulties
to properly display curving solids especially
in line extrusion solids
the question:
there is a set of parameters that improves the yield of curved objects
as there was or was in autocad (I stayed in 2005)
so you could improve the definition of curves or yield in
phase of rendering curved surfaces?

in the image the ring rack gives the idea that the ring is not perfectly circular and also the other accessories I had to make them as cylinders because as rotation solids were not well

 

[alpearchitetto]

Man, technically, I can't answer the only observation of the soap door's beak, then you're making it curved? otherwise you may be able to wear your jacket;o)

 

[render54]

Say it to the grohe
the dxf they are so!
I did it again because the dxf is a unique object
dispenser and support
and then in revit if I imported the dxf
then the render would be all faceted
and a single material,
as well as family of revit I can
change its size in case
and then you want to put, so you can use it
to shoot around soap

ps. idea
He fills it with cream and shoots it in your mouth

 

[render54]

Is that what you write?
this morning I added a double wipe door

 

[alpearchitetto]

I repeat very good good!! But then all I'm doing is making it available or is it just to die of anger?? I'm kidding to make and... okay with soap and jacket. ;o)

 

[render54]

added a new useful moool element
the porter

 

[render54]

to improve I also added toothpaste
However in doing these objects I noticed that revit
in the solid modeling of small objects some
problems meet him especially in rotation solids