delete a group in a multifunction bar tab

[Micim]

I use autocad 2009: I have two groups "interrogation", one on the start tab and one on the instrument board.
I change one by believing it was the one on the beginning and instead it is the one on tools; I say, little bad, I reverse them... and instead not, on the start card they both remain.
Why is it? ? ? ? ? ?
It's true, I could turn off the panel on the start card and I wouldn't see the double of the group, but I'd like to figure out how to delete it just and above all understand why I'm so dumb I haven't understood it yet!
hello and thanks in advance

 

[PlannerRoad]

if you want to delete it completely from the list you have to go into the customization user interface (iupers control) and then in the tabs (under multifunction bar).

 

[Micim]

I thank you very much for the availability, but unfortunately I continue to have problems.
I try to explain to you my operations:
I go to customize user interface then multifunction bar tabs then start-2d; at this point I find my group that I want to delete (ex question then from me renamed question1) button dx remove then apply.
and at this point... there she was still where she was before.
Can the problem be that I renamed it?
Thanks again
I'm a registered user for years, but I've only "disrupted" you when I need and unfortunately my little knowledge (demonstrable from my problem) prevent me from being of help ... sigh sigh sigh

 

[Micim]

Can anyone understand anything about my problem? I haven't been able to solve this yet?

 

[PlannerRoad]

...and instead not, on the start card both remain.... .

Did you just delete one on the start-2d card or both of them?
eliminate both of them, and see what happens.

 

[Micim]

Thank you, I managed ... I kept deleting the group from the tabs, but I didn't see that it was created (not by myself I will be!) a second group question1: eliminated that from groups multifunction bar you solved the problem.
Thank you.