peppe-break
Guest
Hello everyone, as I am beginning to do the thesis of a hard top, and for the hull I wanted to use a 3d orca program to then calculate resistance to motion etc.
the problem is that the dead work of the hull I would like to do a little particular, more aggressive being a hardtop with hips like the audi r8!!
but I asked myself a question.. once you run with 3d orca and various programs, you can change the hull at my liking, or you have a mess? I'm begging that I'm doing it with an orca because I'm not very experienced, it would be a mess to make a decent hull from me. At least I think! !
the problem is that the dead work of the hull I would like to do a little particular, more aggressive being a hardtop with hips like the audi r8!!
but I asked myself a question.. once you run with 3d orca and various programs, you can change the hull at my liking, or you have a mess? I'm begging that I'm doing it with an orca because I'm not very experienced, it would be a mess to make a decent hull from me. At least I think! !