design positioning and table setting

[djcross]

Hello everyone, I'm new to the forum.
I am a mechanical engineer with the first weapons with 3d design, in fact solidworks and autocad I used them only at school level. . . .
for work needs I have to replenish solidworks and I have drawn a piece, the problem arises from the fact that during the modeling and assembly of the piece, I must have made some pastes with the plans. in fact if I tell him to place the piece for example to desta, left etc.... never puts it straight but remains tilted because it refers to blessed plans......the problem is in the table...I can not make views if the piece is tilted... .
exists a method to place the piece without having to redesign everything?

 

[Mike1967]

Hello everyone, I'm new to the forum.
I am a mechanical engineer with the first weapons with 3d design, in fact solidworks and autocad I used them only at school level. . . .
for work needs I have to replenish solidworks and I have drawn a piece, the problem arises from the fact that during the modeling and assembly of the piece, I must have made some pastes with the plans. in fact if I tell him to place the piece for example to desta, left etc.... never puts it straight but remains tilted because it refers to blessed plans......the problem is in the table...I can not make views if the piece is tilted... .
exists a method to place the piece without having to redesign everything?

Relating to us.

 

[djcross]

the problem is that it is a cylindrical piece so the relative view command does not work because it does not make me select anything....... .

 

[Mike1967]

the problem is that it is a cylindrical piece so the relative view command does not work because it does not make me select anything....... .

creates orthogonal plans using circumference and then select those.