design special tool which technique

[RS4]

hello to all of the forum

I would be curious to see the various ways of drawing the following tools with composite and sharp two twists in step or iges format with various software to see designation time and software limitations

geometries

d12.7mm l100

d6.35mm l80

Hi.

Have fun

♪

 

[User1]

I created a circumference on the plane, I put a point on the circumference, I inserted a propeller from the point just entered in direction z, always on the plane of the circumference I created a profile two twist, in the environment part I created a sweep with emptying, that in catia v5 is located under the command coast. the game and done! the particular that I think you have to cure more, will be the geometry of the cutting board that will have certain parameters.

 

[RS4]

I created a circumference on the plane, I put a point on the circumference, I inserted a propeller from the point just entered in direction z, always on the plane of the circumference I created a profile two twist, in the environment part I created a sweep with emptying, that in catia v5 is located under the command coast. the game and done! the particular that I think you have to cure more, will be the geometry of the cutting board that will have certain parameters.

post pictures boys and see

was just what I did I see other suitors with other solutions and other software

Let's go what comes out of force guys

 

[User1]

if you want to see some modeling, you can visit my blog: designerstacatia3d.blogspot.com