development deformed sheet

[ImmerCAD]

Good morning.
I attach a sheet file for which I ask how to achieve deformation development.
I finally added the feature of tearing surfaces (suspended) to achieve the development that however would not be the real one.
I ask if there is a function that allows to achieve theoretical development through the flat preview series.
Thank you for your attention and greeting.

 

[DANI-3D]

Bye-bye.

I have an older version of your cad, I can't open the file. If you attach a step or iges I can take a look at it.

 

[ImmerCAD]

good morning dani.
i attach the step and also the neutral (i used create parametric 3.0).
thank you.

 

[DANI-3D]

with the sheet package you can't develop it, even because it's a piece you can't do with a bending machine, but only molding, and i don't think there's any application that can do it.

 

[ImmerCAD]

Hi, dani, thank you for the answer.
I know very well that the bending process takes place for molding, the probe is that the flattening takes place in the corners where the edge is connected between the walls at 90°, but also here should be the rule of the fact that the piece is printed and not bent with bending press, instead it is quietly flattened then I thought there was to implement some parameter in the functions of edge laceration or surfaces.

to flatten a sheet that undergoes deformation or stretching it is necessary to use an application such as autoform or fti that can be integrated into a creo environment, but they are honest.

I opened a ptc ticket to ask if the simulate can be enough (with the license), provided that this computes the development and not only the meshatura of the material stress.

As soon as I have an answer I will post it.

Thank you again and I greet you.

 

[ImmerCAD]

Good morning.
in a ptc tutorial it is explained how to create deformation areas in the flattening function, to flatten those areas deformed in several directions.
according to the needs it is also possible to create division areas before flattening, with the function division areas.

insert the link of the ptc learning exchange tutorial, to be able to consult it you must be registered:http://learningexchange.ptc.com/tutorial/1396/creazione-di-feature-di-area-di-divisionecordial greetings.